Long Distance Remote Control Parking Lock Battery And Solar Powered
Introduction of parking lock:
Car Parking Lock is an iron mechanical device which can avoid
parking place being occupied by others.
Car Parking Lock is installed on flat cement floor. And it is
generally installed in 1/3 entrance of parking space.
Technical parameters of solar type parking lock:
RUNNING TIME RISES OR FALLS
AFTER RISING ALTITUDE
AFTER DROPPING ALTITUDE
REMOTE CONTROLLED DISTANCE
SIZE OF SOLAR ENERGY PANEL
FUNCTIONAL FEATURES INTRODUCTION
If the battery is short of power or out of service, manual control
can be made by pulling/pressing the rocking arm of the parking
lock, so that the battery can be conveniently taken out for
recharging, replacement or maintenance.
- Power Cut-off on Resistance
The power shall be automatically switched off on external forces
unaffordable in the lifting of the parking lock to protect the
electrical motor from being damaged.
- Power Shortage Indication
When the power is too short to start the parking lock, the
indication lamp on the parking lock will flicker for three times to
remind the user of recharging the battery in time.
- Alarming and Resetting on External Force
For these series parking lock, if the rocking arm is forced to be
lowered when lifting, with the action of the external force, the
front/back angle of the rocking arm will be changed, the parking
lock will alarm to remind the external force applier to remove
external force or remind the managerial staff to make treatment.
The rocking arm will reset automatically after 5~7 seconds.
The position of the foundation for parking lock and ground
installation will be protected by a large external cover. The cover
can only be opened by the user with the key to make theft
More photo car parking lock:
INSTALLATION PRINCIPLE AND METHOD
- Installation Principle
A. Installation Position
The vehicle shall not touch the parking lock when going in and out
of the parking space. The parking lock is suggested to be installed
in the middle of entrance of parking space.
B. Installation Site
The lock is required to be installed on level and dry cement
2. Installation Method
A. Lift the rocking arm manually with hands, open the lock with
key. Open the upper cover to install the lock.
B. Drill three holes (12mm of diameter and 50mm of depth) and
install M8 expansion bolts on the ground according to the locations
of three installation holes on the parking lock foundation.
C. Cover three foundation spacers on the expansion bolts, and then
cover parking lock foundation, install and tighten the bolts to
D. Before using, first insert the plug which the color is
corresponding to the solar panel lead wire into the battery
pins(red for positive electrode and blue for negative electrode).
Then set the battery on level position. Insert the plug into the
socket of the parking lock, sort up the wires.
E. Install the upper cover. Keep the upper and lower fixed blocks
joggling (hold the back of upper cover to push forward as indicated
in the schematic). Then lock the upper cover.